Kliktronic Unit Mounting I'm using a Kliktronic Gear Shift along with the paddle set in my earlier posts. Once James and I had figured the hole centres for the clamp mounting out it was a simple job to fabricate one from some 30x5 mm flat bar. We then used a gear lever from a VFR 750 F and the rose joint from the ST welded together to sort the linkage out between the Klikktronic and the input shaft. Simple engineering, simple solutions. I need to get some decent bolts for the mounting, the ones in the picture are just some I had in the garage. I'm almost ready to modify the rear plastics to accomodate the diagonals to the bike frame. The rear end should be done in the next few days health permitting.